NS4 Stereo & mono outputs

[martypy]

I would like to configure my Stage 4 to have stereo outputs 1 and 2 to sent to my L & R powered floor monitors, and a mono signal to sent to output 3 for the front of house mixer. I can't figure out how to program the output bus channels for all 3 outputs (stereo AND mono) for all the sections (organ/piano/synth). Also, if this can be done, can it be done globally or only a program by program basis.

[Kaffimusic]

I´d recommend a small stage mixer with a FX/AUX channel, just for you. It can split the signal. Main outs is stereo, can go anywhere you like (I send that to the PA) and the FX send can be used as mono line. I use that for my personal monitor. I am 100% independent of what the techguy does. I control how well I hear myself. And can check stuff while I am muted.
When more keyboards come into play, you´d need something like that anyway.

[Normski]

Page 57 /58 in the manual.

[glombi]

Does the manual already reflect V1.4(2)?

V1.40 (2024-07-03)

Added a new Global option in addition to the Program Specific setting, in Output menu.

In Global mode the Bus routing is inactive, and Sections/Layers are assigned directly to outputs.

Program Specific mode functions as previously, where Bus to Output assignments (Main, Sub I-III) are set globally and Section/Layer to Bus assignments are stored per Program.Fixed issue where Extern Layers would play outside of splitpoint, with Split XFade turned On

[martypy]

Page 57 /58 in the manual.

The manual isn't clear to me on this set-up. Believe me, it's always the first place I look.