Page 1 of 1
Saving Program View on NW2
Posted: 10 Dec 2023, 17:53
by jason88
On the Wave 2, when I hit Shift + Prog View it allows me to change the display view of the performance info. I really like the setting that shows the layer parts with the program number is smaller font at the top row (hope this makes sense). Question is, after changing the view to my preference, it always defaults back tot the original view format when turning the unit back on. Is there a way to save the view format in the system settings, or is this just something that will need to manually change every time I cycle power? Thx!
Re: Saving Program View on NW2
Posted: 10 Dec 2023, 20:07
by DJKeys
Yes, this is the intended behavior. You will need to enter Program View upon restart, but it will stay that way until you turn the unit off-
-dj
Re: Saving Program View on NW2
Posted: 23 Jul 2024, 22:29
by antoc
jason88 wrote: ↑10 Dec 2023, 17:53
On the Wave 2, when I hit Shift + Prog View it allows me to change the display view of the performance info. I really like the setting that shows the layer parts with the program number is smaller font at the top row (hope this makes sense). Question is, after changing the view to my preference, it always defaults back tot the original view format when turning the unit back on. Is there a way to save the view format in the system settings, or is this just something that will need to manually change every time I cycle power? Thx!
it's really annoying this behavior, I don't think it would cost to put it as an option in the system menu. come on Nord!
