Saving Program View on NW2
-
jason88
- Posts: 7
- Joined: 22 Nov 2023, 19:58
- 1
- Your Nord Gear #1: Nord Wave 2
- Has thanked: 4 times
- Been thanked: 2 times
Saving Program View on NW2
On the Wave 2, when I hit Shift + Prog View it allows me to change the display view of the performance info. I really like the setting that shows the layer parts with the program number is smaller font at the top row (hope this makes sense). Question is, after changing the view to my preference, it always defaults back tot the original view format when turning the unit back on. Is there a way to save the view format in the system settings, or is this just something that will need to manually change every time I cycle power? Thx!
Nord Wave 2, Kronos 2, Viscount Legend 70s Artist-W, Vox Continental 73, Opsix
-
DJKeys
- Patch Creator
- Posts: 2158
- Joined: 11 Apr 2011, 17:11
- 14
- Your Nord Gear #1: Nord Stage 3
- Your Nord Gear #2: Nord Wave 2
- Location: Las Vegas
- Has thanked: 432 times
- Been thanked: 877 times
Re: Saving Program View on NW2
Yes, this is the intended behavior. You will need to enter Program View upon restart, but it will stay that way until you turn the unit off-
-dj
-dj
Nord Stage 3
Nord Wave 2
Yamaha U3
iMac i7 15.4
Studio One 5.5.2
Nektar T4
Drawmer DL 241
Focusrite ISA Two
Focusrite Clarett 8 Pre
-
antoc
- Posts: 19
- Joined: 30 Sep 2011, 14:31
- 14
- Your Nord Gear #1: Nord Stage 4
- Location: Novara, Italy
- Has thanked: 12 times
- Been thanked: 6 times
- Contact:
Re: Saving Program View on NW2
it's really annoying this behavior, I don't think it would cost to put it as an option in the system menu. come on Nord!jason88 wrote: ↑10 Dec 2023, 17:53 On the Wave 2, when I hit Shift + Prog View it allows me to change the display view of the performance info. I really like the setting that shows the layer parts with the program number is smaller font at the top row (hope this makes sense). Question is, after changing the view to my preference, it always defaults back tot the original view format when turning the unit back on. Is there a way to save the view format in the system settings, or is this just something that will need to manually change every time I cycle power? Thx!
