Page 1 of 1
Urgent help needed! Output problem.
Posted: 01 Jul 2016, 16:34
by howardeastwood
Hi all.
Hoping you can help.
Output 1 on my stage 2 has snapped off and half of the thread is still screwed inside the keyboard.
As a temporary is it possible to use output 2 as a mono channel without having to faff and re route the samples to different outputs? I.e. literally plug one jack lead into output 2 and I'm good to go? Or will that only give me one side of the audio?
Re: Urgent help needed! Output problem.
Posted: 01 Jul 2016, 16:35
by howardeastwood
I have 3 festival slots this weekend so your urgency in helping me would be much appreciated.
Thank you.
Howard
Re: Urgent help needed! Output problem.
Posted: 01 Jul 2016, 16:44
by maxpiano
You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.
Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)
Re: Urgent help needed! Output problem.
Posted: 01 Jul 2016, 21:29
by MrSitcom
maxpiano wrote:You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.
Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)
Rotary won't be cut out, it's not a Global effect. Reverb and compressor unfortunately will be cut out as you said
Re: Urgent help needed! Output problem.
Posted: 02 Jul 2016, 08:23
by maxpiano
MrSitcom wrote:maxpiano wrote:You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.
Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)
Rotary won't be cut out, it's not a Global effect. Reverb and compressor unfortunately will be cut out as you said
You are right, I stand corrected.