Urgent help needed! Output problem.

[howardeastwood]

Hi all.

Hoping you can help.

Output 1 on my stage 2 has snapped off and half of the thread is still screwed inside the keyboard.

As a temporary is it possible to use output 2 as a mono channel without having to faff and re route the samples to different outputs? I.e. literally plug one jack lead into output 2 and I'm good to go? Or will that only give me one side of the audio?

[howardeastwood]

I have 3 festival slots this weekend so your urgency in helping me would be much appreciated.

Thank you.
Howard

[maxpiano]

You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.

Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)

[MrSitcom]

You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.

Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)

Rotary won't be cut out, it's not a Global effect. Reverb and compressor unfortunately will be cut out as you said

[maxpiano]

You can, enable Mono Mode (Shift-Slot A) and then use Output 2 only, course you will lose the stereo effect this way.

Otherwise you can route all sections to Output 3/4 but that will cut out from the signal path the Global effects (rotary, reverb and compressor)

Rotary won't be cut out, it's not a Global effect. Reverb and compressor unfortunately will be cut out as you said

You are right, I stand corrected.