How to change parameters in system settings?

[Ben E Factor]

Can't figure out how to change parameters in system settings, total mystery..
Its funny how in the manual they say "Set this to OFF to..." but how to do it, is not explained.

[SteveNordP3]

If I understand what you're asking - please see the very top of page 15 in your manual. It provides specific instructions to do what you want.

"Global system and MIDI settings, sound settings for the Piano section and various options for sustain and Control/Volume pedals are ac- cessed through the SYSTEM, MIDI, SOUND and PEDAL menus. Menus are browsed with the PROG/MENU dial, and values are changed using the same dial while pressing VALUE."

Good luck!

[Ben E Factor]

I wanted to change the frequency to 432 Hz

[SteveNordP3]

Ok - I haven't done this but my reading of the instructions on that page suggests:

1) press the SYSTEM button
2) turn the PROG/MENU dial until you see the FINE TUNE option
3) press and hold the VALUE button while turning that same PROG/MENU dial (to the left I would assume) to drop the tuning to 432hz

See if that works. Good luck!