Neo Ventilator 2 to the Ashby Solution Halfmoon Switc

[RussTobin]

Hello. Does anyone know how to connect the Neo Ventilator 2 to the Ashby Solution Halfmoon Switch for the Electro 6D 61?
I’ve tried everything.

Thanks,
Russ

[Hlaalu]

In the Vent you can set which type of connected switch so that it can correctly interpret its position. You find how to change this on page 27 of the Vent manual: https://neo-instruments.com/wp-content/ ... _de_en.pdf

[RussTobin]

The problem is, that I’ve plugged the Halfmoon Switch into the remote on the Ventilator 2. But where does the Ventilator 2 plug into?

Thanks,
Russ

[FZiegler]

So, you have a Nord Electro, a Neo Vent II and (e.g.) an Ashby Gigging Halfmoon.

The Neo Vent II - as always - is connected to audio-out of the Electro. What your Vent needs to work, is a mono signal. But you can plug both channels from your Electro into the Vent and use the bypass button if you don't play organ sounds. For controlling the Vent, you'll plug your Gigging Halfmoon into the remote jack of you Vent - as you did. The Vent Out L and Out R jacks are what you now connect to your amplification. I don't see a direct way to play with your headphones - but I don't have a Vent, never tried.

Set the pot position for the remote setting on the Vent to 9:00 (meaning "Switch2" mode). If you've got an Ashby Demi Luna switch, configure it in a way that it simulates a Hammond CU-1 halfmoon switch.