Page 1 of 1

Nord G2 Editor Help!

Posted: 29 May 2015, 05:57
by JuanPC
Hi,
I'm using the Nord G2 Editor to emulate my Yamaha CS-15D...
Problem is: LFO ---> VCO.
In hardware: Modulation at 100%, LFO Square wave has +6 notes & -9 notes, like police sirens.
In Software: I can make a +6 & -6 or +9&-9.
But can't give different values to positive & negative.
LevelAdd affects both +&-,
Splitting LFO signal with 2x LevelConvert does not work.

Just need some diodes to split the signal, and a Bias of -3 to the -6 signal.

Any Ideas.?

Re: Nord G2 Editor Help!

Posted: 29 May 2015, 13:31
by stiiiiiiive
It's been a long time since I patched, but I think I would have used that level converter to separate the positive and negative parts of the LFO, multiplying one of them and add them again.

I'll have a look. Please ring me if I don't come back :)

Re: Nord G2 Editor Help!

Posted: 30 May 2015, 20:00
by stiiiiiiive
So.

It was not the Converter but the Rectifier :)

Here is some material :
Asylmtric LFO for G2, halellujah!
Asylmtric LFO for G2, halellujah!
Capture d’écran 2015-05-30 à 19.54.23.png (64.28 KiB) Viewed 2073 times