Nord's classical Virtual Analog Synth Nord LEAD 1/2/2x/3/4/A1 and Nord Rack versions

Re: problems with output level on nord

Postby poweiss » 18 May 2020, 05:23

mjbrands wrote: As it turned out, in my case it was caused by using stereo cables to connect the synths to my interface. The interface was expecting a balanced connection because I was using a 1/4" TRS plug (stereo). When I switched to a cable with 1/4" TS plugs (mono), the problem went away and the levels were as they should be. With my Virus it worked okay with both types of cables, but that was because it can either send a balancer or unbalanced (line-in) signal, based on the type of plug you plugged into the synth.


This!!!! I was really at a loss for a while. Switched to a mono cable and it fixed it. Thank you mjbrands!
poweiss
 
Posts: 1
Joined: 18 May 2020, 05:21
Country: United States of America
Has thanked: 0 time
Been thanked: 0 time
Your Nord Gear #1: Nord Electro 4

Re: problems with output level on nord


Sponsor
 

Previous

Return to Nord Lead / Rack Forum



Who is online

Users browsing this forum: No registered users and 0 guests