Page 1 of 1
Creating sample
Posted: 20 Nov 2012, 12:27
by Georg
Hello everybody,
my question is:
I would like to create a short sample which repeats from the beginning again and again. Its a conga sound from Ry Cooder - Drume negrita.
When I sample the sound starts but at the end it does not repeat from the beginning.
What mistake do I make?
Thanks
Georg
Re: Creating sample
Posted: 20 Nov 2012, 14:45
by Lyonart
Hi
In the Sample Editor you need to check the loop tabs to make sure the loop start point is at the beginning of the sample and that the loop length is also the full length of the sample. Another crucial thing is to make sure the loop length variation is set to 0 otherwise the loop length will not be the same for each repeat (I think normally this is set to 25 as default).
Hope this helps.
Geoff
Re: Creating sample
Posted: 20 Nov 2012, 17:27
by Georg
Thanks a lot. I´ll try and will report the result.
Re: Creating sample
Posted: 20 Nov 2012, 17:41
by Georg
Yes! It works! Once again thank you so much for helping. I love this forum!
Re: Creating sample
Posted: 20 Nov 2012, 20:27
by Lyonart
Georg wrote:Yes! It works! Once again thank you so much for helping. I love this forum!
No problem, glad to help - it's good to know that my memory of how to do things is not failing just yet
.