Nord User Forum

Hi!

Yesterday I encountered a strange issue. I found that one split point in one of my programs had changed. I'm pretty sure that I did not store any changes lately. But you never know...

BUT, when I tried to correct that, another strange thing happened. I selected the middle split point, and wanted to move it back up again. What happened instead iss that the upper and the middle split point moved down at the same time?!

I could reproduce this several times. Afterwards I was able to correct both split points again.

This is the first encounter, but it makes me a little bit nervous, as my first gig is coming up in three weeks.

Is this a known issue, or can single programs suddenly go bad?

Thanks,
glombi

I've never had an issue, but happy to try and recreate the issue if you send the steps...