Nord User Forum

Hi so I am specifically talking about the angelic choir6 oh patch. I noticed if I play with the patch after maybe a few seconds the patch doesn't seem to respond correctly to the velocity I'm pressing, as if quieter. When I switch patches it goes back to normal. Any1 have any idea why this happens?

I have uploaded a sample clip. So I'm basically fiddling around, then you'll notice before I switch I play the same note, switch a patch, back to the choir and the patch seems to have gone back to normal volume.

I cannot open the video but here's a hint: is there any MW or CtrlPedal morphing active on that patch? If so, check the MW and CtrlPed position are zeroed (or try to move them) and retest.

I started from an empty patch, turned on the synth engine, did a sound init of the synth engine, selected Angelic Choir6 Oh, and tried to see if I could get the same result. I even switched to the next patch and came back.

Is there anything I missed? It didn't reduce the volume.

• f.mp3

dmamfmgm wrote:I started from an empty patch, turned on the synth engine, did a sound init of the synth engine, selected Angelic Choir6 Oh, and tried to see if I could get the same result. I even switched to the next patch and came back.

Is there anything I missed? It didn't reduce the volume.

• f.mp3

Interesting yours sound completely raw and volume remains completely the same. Perhaps there's something going on underneath.. I'll have a look through again and try to find out what's happening

Hey so I ended up just redoing from scratch from an empty template and now it's ok. My guess is I may have changed it to a waveform hence explaining the change in volume even if still applying the same pressure.