C2D....Can the LCD display level of light be adjusted?
Posted: 09 Oct 2023, 15:14
Can the LCD display level of light be adjusted? I looked in the user's guide and it appears it can't be.
Nord User Forum
This 'unofficial' Forum is dedicated to the Clavia Nord Keyboards, including the Nord Stage, Nord Electro and Nord Piano. Discuss any issues around Nord's keyboards, share your favorite patches, samples, and music. We are not affiliated with Clavia!
https://www.norduserforum.com/
C2D....Can the LCD display level of light be adjusted?
Page 1 of 1
Re: C2D....Can the LCD display level of light be adjusted?
Posted: 09 Oct 2023, 15:39
It cannot be adjusted via any user/software setting, maybe only via a trimmer on the display/panel board (if present, difficult to confirm without a schematic).
Re: C2D....Can the LCD display level of light be adjusted?
Posted: 09 Oct 2023, 20:02
OK thanks.
Re: C2D....Can the LCD display level of light be adjusted?
Posted: 09 Oct 2023, 20:49
I recently installed a yellow display in a Studiologic VMK 188 instead of the old (which had become dark) bluish one.
These 16x2 displays are very cheap (3-5 euros) and are actually always connected to the device
either via SPI or via I2C with a small controller board on which there is a potentiometer for the brightness.
For someone with some soldering experience and Arduino knowledge, it's child's play to replace it if it no longer lights up properly.
Greetings and good luck
These 16x2 displays are very cheap (3-5 euros) and are actually always connected to the device
either via SPI or via I2C with a small controller board on which there is a potentiometer for the brightness.
For someone with some soldering experience and Arduino knowledge, it's child's play to replace it if it no longer lights up properly.
Greetings and good luck
Re: C2D....Can the LCD display level of light be adjusted?
Posted: 10 Oct 2023, 02:18
Good to know this.