Page 1 of 1
Sample Editor: Choosing one sample vs all samples
Posted: 20 Feb 2012, 01:15
by Organ Morgan
Hi!
I´ve sampled 6 instruments, and I want to make 2 .nsmp versions, one straight forward (No loop), and one with Long loop.
When I was finally done doing this, I realized that the "No loop" was only set for one of the keys, not all.
How can I do this for the entire range, instead of selecting No loop on one and one sample/key?
Re: Sample Editor: Choosing one sample vs all samples
Posted: 20 Feb 2012, 05:45
by Hanon_CTS
Organ Morgan wrote:Hi!
I´ve sampled 6 instruments, and I want to make 2 .nsmp versions, one straight forward (No loop), and one with Long loop.
When I was finally done doing this, I realized that the "No loop" was only set for one of the keys, not all.
How can I do this for the entire range, instead of selecting No loop on one and one sample/key?
Hello Organ Morgan,
Welcome to the forums,
In the Sample Loop/Stop tab, there is a section called "Apply on All"
If you click this with "No Loop" bulleted, it will set "No Loop" for all samples.
- Apply_Loop.PNG (48.35 KiB) Viewed 1979 times
Cheers, Hanon
Re: Sample Editor: Choosing one sample vs all samples
Posted: 20 Feb 2012, 13:05
by Organ Morgan
Thanks a lot! I didn´t understand that feature..until now.
Re: Sample Editor: Choosing one sample vs all samples
Posted: 20 Feb 2012, 15:25
by Hanon_CTS
Organ Morgan wrote:Thanks a lot! I didn´t understand that feature..until now.
I'm glad that I could help.
Nord Sample Editor (NSE) has a fairly comprehensive manual
Nord Sample Editor Manual
I keep thinking that I'll write a tutorial about sampling, but stop, because I'm hard pressed to say something that's not already in the manual.
Cheers, Hanon