Nord User Forum

I want to morph-assign to a control pedal the switching on-off of an effect. Is that possible?
I now programmed the morf with rate/tempo and amount set to minimum, but that gives not the same sound as with the effect (a-wah-1 in this case) actually switched off.
I found a midi-controlnumber that should do the switch but is that feasible through a control-pedal?
Thanks for helping out this newbie who is very pleased with his NS2 with its exceptional grandpiano sounds.

You cannot do that with the NS2 control pedal but you could do it with a Midi footswitch (but they are quite expensive and maybe too much for the purpose) or using the MIDI Solutions Footswitch Controller http://www.midisolutions.com/prodfsw.htm, which enables to use a footswitch and generate any Midi Message.

A more complex solution would be to use a computer to detect the Midi message (generated by the footswitch of NS2 you wish to use), transform it to the desired ControlChange and sendi it back to NS2 (on Windows you can do this using the freeware MidiOx utility)