Nord User Forum

When using the FX on the NW2, there is the option to set the rate to master clock.
On my NW2 the following occurs:
When I use TREM or PAN and switch the rate to master clock, the led turns on.
When I use any other FX, and switch the rate to master clock, the led doesn't turn on. The screen does say "Fx MstClk" is on.

Has somebody else noticed this, or am I the only one with this behavior?

I just looked at this and found the same behavior, only Trem and Pan in that section activate the Mstr Clock LED. Delay does the same thing, but Ring Mod, Phaser, Chorus, Ensemble and Vibe appear not controllable by Master clock. Perhaps Clavia does not consider these time-based FX for some reason.

-dj

But the screen says that FX masterclock is on, when you turn it on, only the led is not turned on.

Edit:
Found it in the manual:
Turning MST CLK (Shift + Rate) synchronizes the effects Rate for the Trem and Pan effects with the Master clock. In Mst clk mode, the Rate is presented as subdivisions of the Master clock tempo.

Cool-

-dj