Nord User Forum

Just picked up a new Nord Drum 3P. In the manual it says "Dy - Dynamics: There are six different dynamic response curves that can be individually applied to each of the channels."

However, when I change this setting (shift + pad mode button twice, turning the selection dial), it changes it for all of the channels, and I can't seem to figure out a way to isolate the setting for one channel. The trig/mono lights for all of the channels turn green when I enter this setting mode.

Hi Isoparmesan, welcome to the forum!

Sorry for the late response. The manual does suggest it can be set per pad, I don't own the 3p, but perhaps I can help checking if it's a global setting or not.. When you have the dynamics parameter in your display, use the channel/pad selection buttons to check the parameter for a couple of pads, if they all have the same setting, select one channel, change the dyn parameter with the knob, then check the other channels/pads, if they now all show the new setting, the dynamic curve is set globally for all 6 channels..

Hope this helps,
Albert