Output Routing
Output Routing
Hello! I would like to buy a Nord Stage 2 EX. Is it possible to layer two synths and rout the one to Output 1&2 and the other one to Output 3? Thanks!
-
maxpiano
- Patch Creator
- Posts: 7324
- Joined: 27 Jun 2011, 13:29
- 14
- Your Nord Gear #1: Nord Stage 3
- Location: Italy
- Has thanked: 561 times
- Been thanked: 2574 times
Re: Output Routing
Hi,
yes it is possible, as explained in the manual (System menu)...
Synth Audio A/B Output
This allows you to set which channel output pairs (or mono output) to use for the Synth A and B section . Use the Slot A & B buttons to access the settings for each Slot . If the Output Routing (see above) is set to “Program”, these settings will be saved with the program .
Range: "1&2”(Default),”3&4”,"3”,”4”
yes it is possible, as explained in the manual (System menu)...
Synth Audio A/B Output
This allows you to set which channel output pairs (or mono output) to use for the Synth A and B section . Use the Slot A & B buttons to access the settings for each Slot . If the Output Routing (see above) is set to “Program”, these settings will be saved with the program .
Range: "1&2”(Default),”3&4”,"3”,”4”
Last edited by maxpiano on 23 Feb 2019, 10:27, edited 1 time in total.