I just bought a used Nord C1 and I'd like to reload the original sounds settings.
I read and reread the doc of the C1 midi-part, but I don't understand how to use the syses file.
With my mac, I run "SysEx Librarian" program, I load the file NordC1Factory-3.syx (downloaded on the Nord website), I do "play" and nothing happens ...
Should the C1 be connected to USB or MIDI jack ? Which parameters to choose in C1 ?
If anyone could help me!
Thank you.
C1 how to original sounds settings reload
-
roberstein
- Posts: 8
- Joined: 20 Jan 2014, 16:56
- 11
- Your Nord Gear #1: Nord Electro 3
- Your Nord Gear #2: Nord Stage 2
- Has thanked: 1 time
- Been thanked: 1 time
-
maxpiano
- Patch Creator
- Posts: 7119
- Joined: 27 Jun 2011, 13:29
- 14
- Your Nord Gear #1: Nord Stage 3
- Location: Italy
- Has thanked: 540 times
- Been thanked: 2499 times
Re: C1 how to original sounds settings reload
Check page 19 of the C1 Manual (available on Nord site) about restoring Sysex dumps (key point: ensure Memory Protection is switched off).
C1 does not support MIDI over USB so you need to use a MIDI interface, make sure also you are using a good quality one as some cheap MIDI USB cable interfaces fail to transfer sysex streams properly.
C1 does not support MIDI over USB so you need to use a MIDI interface, make sure also you are using a good quality one as some cheap MIDI USB cable interfaces fail to transfer sysex streams properly.
Last edited by maxpiano on 31 Jan 2017, 15:15, edited 5 times in total.
- These users thanked the author maxpiano for the post:
- pablomastodon
-
roberstein
- Posts: 8
- Joined: 20 Jan 2014, 16:56
- 11
- Your Nord Gear #1: Nord Electro 3
- Your Nord Gear #2: Nord Stage 2
- Has thanked: 1 time
- Been thanked: 1 time