Page 4 of 4
Re: Problems after update to 1.42!
Posted: 18 Aug 2018, 12:02
by analogika
Copy the link for the latest Mac firmware updater from the Nord website, pate it into the browser address bar and edit the last digit so that it reads „1.40“ rather than „1.42“.
Re: Problems after update to 1.42!
Posted: 18 Aug 2018, 16:40
by aureliopenna
I had the same problem hear too. Voice Stealing, Ghost sounds and Delay going wrong.
Back to 1.40. Which is sad, I was kind of enjoying the piano releases and the loud compressor.
Re: Problems after update to 1.42!
Posted: 20 Aug 2018, 18:45
by kalimero
Transitions without interruptions when changing programs since the last update no longer exists
Re: Problems after update to 1.42!
Posted: 20 Aug 2018, 23:14
by ADSRLFO
Always exist ! but Seamles program change in the system menu was put to off after the update ....just put it on :- )
Re: Problems after update to 1.42!
Posted: 21 Aug 2018, 12:25
by Szisztema
PriitS wrote:os 1.42
I have that synth polyphony issue as well. Like it will choose randomly when and which notes should not be played today...
No difference, is there A or B or both switched on, mono or stereo samples (synth section only!).. no difference - bug still on! Sometimes it will play all notes, but mostly not... just double checked - even if i play only four note chord - will be heard 3 notes 4, 3, 4... (polyphony is 32).
I hope They do not have to recall Stages back to factory to change some chips or something..
Same problem with synth polyphony.
Re: Problems after update to 1.42!
Posted: 22 Aug 2018, 18:59
by wallhara
I also suspect the update to 1.42 broke velocity on my NS3. I would like to test it by going back to 1.40, but I don't have the update file anymore.
Is there anyplace where old firmware files are stored?
Thanks.
Re: Problems after update to 1.42!
Posted: 22 Aug 2018, 20:13
by alcools
See the previous page
Re: Problems after update to 1.42!
Posted: 23 Aug 2018, 04:13
by jpgour
I'm having a problem with the delay effect section not sync-ing to the master clock. Can any one replicate or confirm this?
Specifically, if I set the delay tempo to master clock sync, the delay will sync to 120 BMP, regardless of the master clock tempo.
Thanks
Re: Problems after update to 1.42!
Posted: 23 Aug 2018, 15:26
by Schorsch
New update v1.44 is available, unfortunately not yet addressing most of the issues discussed in this thread
Re: Problems after update to 1.42!
Posted: 24 Aug 2018, 13:44
by Bjosko
Well, new OS 1.46 out now, that are a fix for the Masterclock/Delay issue.