Nord just released v1.30 for the Stage 4.
Let’s all see what is improved and fixed, I can see many improvements I like!
examples: rotary bass-horn balance, higher sample polyphony (56 voices!!), morph led updates, fixes when loading synth presets, 8 line program view (could be a Song Mode alternative??)
https://www.nordkeyboards.com/update-hi ... e-history/
V1.30 ((2024-06-12)
General:
Program format/version updated
General optimisations and performance improvements
Introduced an 8 line Program View showing all programs within a Page.
Synth/Samples:
There are now 56 voices for Sample Synth (previously 48).
Added support for special release behaviour for String samples supporting this feature.
Loading single layer Synth presets could affect KB Zone settings for other Layers. Fixed
Improvements to note start times esp. in regards to samples and multiple layers.
“Sample Select memory” is now reset when changing programs, i.e. after program load the first sample in each category is displayed rather than previous selection
Arpeggiator Keyboard Sync in section/group mode would only work if layer A was active. Fixed
Synth Glide could become inactive for a Layer, if a non-pitched sample had previously been loaded. Fixed
Updates to enhanced Unison and round-robin rules for samples supporting these features
Menus:
Added Overviews to last pages of Output, Pedal and MIDI menus. The Overview pages also allow for focusing and changing settings (using Page buttons and dial).
Added option for restoring to default settings, in System menu. This function resets settings in System, Pedal, MIDI, Sound and Output menus to defaults. Menu settings that are stored in programs (Section/Layer settings in Output menu, Extern and Aux KB settings) are not affected.
Added Rotary Bass/Horn balance to Sound menu
MIDI/Extern:
Synth UI is now disabled for Extern layers, apart from features/controls that can be used in Extern (Arpeggiator, Osc Ctrl/Value 1, Freq/Value 2, Pedal/Pstick settings etc.)
Extern display was updated with larger graphics and improved visualization of morphs on extern parameters.
Una Corda and Sostenuto (left/middle pedals) are now sent on Extern channel as well.
Arpeggiator was not sent on Extern when held using sustain pedal. Fixed
Arpeggiator on Extern using KB Hold was not turned off is Layer was set to non-Extern mode. Fixed
Pedals:
Automatic changing of pedal settings, with incompatible pedals, has been removed. There is still a notification about this however, and a pedal becomes inactive when set wrong
Display/Panel:
Prog list is now exited when entering Live mode
Piano list centered on wrong item when scrolling. Fixed
Mst Clk display can now show hints
Minor changes to KB Split menu
Entering Sample Category List with 2 or less categories in list caused graphical issues in display. Fixed
Pressing down Delay tempo/tap button now shows dedicated Delay tempo/subdiv screen (this can also show hints)
Pressing tap button and then (quickly) turning program dial could disable program loading (until Shift was pressed). Fixed
Some sample categories could be cut off in Synth display. Fixed
Layer buttons now have hints in “simple” prog view mode
New Piano Select hints
Monitor button no longer exits Preset view
Update to Farfisa drawbar visualisation when setting up morphs
All LEDs apart from used morphs LEDs are now turned off when pressing morph button
Morphed drawbars are now visualised in display as well
Various:
Rotary Speaker morph now goes from Slow or Stop to Fast, depening on panel setting. Previously always between Stop/Fast.
Added Swap option for Morph Copy/Paste
Mst Clk KB Sync Off was same as Soft. Fixed
- Various other fixes
Removed ability to set split point to “Off” with turn of dial in Split view. Now “Off” is set with corresponding button (Low, Mid, High).