Nord User Forum

I use one of the connectors for the music stand. Adapted a mike stand, so that it fitted in. See photo. Works very well, but of course, like all stands directly connected to your keyboard or keyboard stand, the sound of you hitting the keys could mechanically transfer to the microphone.

I changed a mike stand, so that it can be fitted in one of the holes for the music stand, at the back of the Nord stage. It works well.

You'd probably get some vibrato as well every time your stand gets swinging a bit.

And I'd only put that mic boom into that connector if I'd already ordered a spare connector in case it's worn out. The lever arm of the boom will greatly increase the forces on the holder.

Seriously, I wouldn't use that nicely done work on stage.

Although I could not see any damage after one year of using the connector in this way, I replaced them by a connector I printed on my 3d printer. It is easy to replace. For those who wish to print it, I attach the 3d file.

TvdLa wrote:Although I could not see any damage after one year of using the connector in this way, I replaced them by a connector I printed on my 3d printer. It is easy to replace. For those who wish to print it, I attach the 3d file.

That would be great! Have you thought about printing a solution as iPad holder as well?

verbalakrobat wrote:

TvdLa wrote:Although I could not see any damage after one year of using the connector in this way, I replaced them by a connector I printed on my 3d printer. It is easy to replace. For those who wish to print it, I attach the 3d file.

That would be great! Have you thought about printing a solution as iPad holder as well?

For iPad holders you may look at this thread: nord-stage-forum-f3/ns2ex-compact-3d-pr ... 21817.html

I've got some from the OP for my NS, they are good

Schorsch wrote:

verbalakrobat wrote:

TvdLa wrote:Although I could not see any damage after one year of using the connector in this way, I replaced them by a connector I printed on my 3d printer. It is easy to replace. For those who wish to print it, I attach the 3d file.

That would be great! Have you thought about printing a solution as iPad holder as well?

For iPad holders you may look at this thread: nord-stage-forum-f3/ns2ex-compact-3d-pr ... 21817.html

I've got some from the OP for my NS, they are good

Thanks, Schorsch. I dropped him a message already

I adapted my mic stand for singing with my stand that has holes in it on the sides... It's a quick lok mic stand that bolts on....