Nord User Forum

This 'unofficial' Forum is dedicated to the Clavia Nord Keyboards, including the Nord Stage, Nord Electro and Nord Piano. Discuss any issues around Nord's keyboards, share your favorite patches, samples, and music. We are not affiliated with Clavia!
https://www.norduserforum.com/

Morph wheel not always in full range

https://www.norduserforum.com/viewtopic.php?t=23308

Page 2 of 2

Re: Morph wheel not always in full range

Posted: 03 Feb 2023, 11:19
by maxpiano
Schorsch wrote:No, just moving the MW up and down withput touching any of the volume knobs. It happens when you move the MW relatively hard to the upper or lower stop, as if it then springs back a little at the end due to the hard stop or something like that. I should probably be a bit more sensitive with it and moving it more smooth :roll:
Bouncing could be a problem, if it does it also when moving gently then maybe you need to open NS3 and re-tighten the wheel to the pot?

Re: Morph wheel not always in full range

Posted: 03 Feb 2023, 11:52
by Schorsch
maxpiano wrote:Bouncing could be a problem, if it does it also when moving gently then maybe you need to open NS3 and re-tighten the wheel to the pot?
Bouncing is the word I was missing in my description :facepalm: .... I will monitor it and if it get's worse I will open the nS3 and see if I can fix it. Thanks all!

Re: Morph wheel not always in full range

Posted: 18 Feb 2023, 21:48
by KeyBard
Perhaps your connector is a bit loose. I had this problem and followed the advice on this post which fixed it on my NS3C: nord-stage-forum-f3/possible-quick-fix- ... 14450.html
All times are UTC+02:00
Page 2 of 2

Powered by phpBB® Forum Software © phpBB Limited