Button problems on Electro 6

[DirkW]

Hi,

Yes it is, at least on NE6 it was. If you feel comfortable to do so that is. Just lift the cap and it will come off. Then you’ll see the spring below it, remember how it is oriented (take picture) and lift it out. I did so and tweaked the spring a very small bit before putting it back. Took me two attempts to find out how to bend it. I dissasembled a working button for comparison. This was really a minimal bend. Put the spring back with correct orientation an put the buttoncap back. On my NE6 it has been working fine for months now.

[sstrochnis]

Years later, your simple solution has solved a problem I had with an organ drawbar for a loooong time, thank you so much !
I bent it just slightly, feels like it shouldn't work but it just does hahaha

[ericL]

Can you folks please share any pictures you might have with the process for removing the buttons and adjusting underneath?

Thanks!

[pterm]

Can you folks please share any pictures you might have with the process for removing the buttons and adjusting underneath?

From earlier in this thread:
https://www.phase57.com/build/nord-modu ... r/buttons/