Page 2 of 2
Re: MIDI hub or another solution?
Posted: 10 Jun 2021, 22:48
by Bjosko
In the A, you have to defined which channel to let through.
Shift + Midi, then hold Shift and scroll to t and select the channel
Re: MIDI hub or another solution?
Posted: 10 Jun 2021, 23:19
by catosim
Bjosko wrote:In the A, you have to defined which channel to let through.
Shift + Midi, then hold Shift and scroll to t and select the channel
Yup, I've got that covered.The slot channels are different from my Soft-through channel.
If the soft channel wasn't right, I would not get any contact with the D-05 in my chain.
Thank you for the effort
Re: MIDI hub or another solution?
Posted: 10 Jun 2021, 23:41
by Bjosko
Perhaps it only send aftertouch from the global channel, and you for example are sending through on a different channel?
Re: MIDI hub or another solution?
Posted: 11 Jun 2021, 06:17
by maxpiano
Bjosko wrote:C1884931-DDAC-47BF-A181-4C86AFAA94F1.jpeg
Seems like it are transmitting aftertouch
Interesting but I only see Note On/Off in the picture and a Reset, no AT (unless that Reset in your MIDI Monitor is the AT? Quite strange to see it represented in that way, since AT is a specific MIDI message)
Re: MIDI hub or another solution?
Posted: 11 Jun 2021, 07:24
by Bjosko
Thats the brown colored values.
I will try again tonight with a synth as the 3. In chain.
(Hydrasynth, so not sure if it react on regular AT since itself are using poly aftertouch).
Re: MIDI hub or another solution?
Posted: 27 Aug 2021, 11:40
by Klangwerk
Hi catosim,
I play with the same gear. I assume you are using the extern-section for that?
Maybe the soft-thru settings. Send on load in NS3?
The D-05 has Channel-Aftertouch. Here you will find the BIG MANUAL with al lot of MID-Implementations:
Good luck,
Helmuth
