Nord User Forum

BuckW wrote:Do you have to update to v1.60 to have this feature?

Any release from 1.60 and on has that feature, so you just have to update to the latest available (which is 99% of the cases a good choice, NS3 is at 2.62 currently)

maxpiano wrote:

BuckW wrote:Do you have to update to v1.60 to have this feature?

Any release from 1.60 and on has that feature, so you just have to update to the latest available (which is 99% of the cases a good choice, NS3 is at 2.62 currently)

Thanks. I have ove of the first. I think I'm v1.04. I guess I'll need to back up my programs first before I update it.

If you use MIDI, you'll experience a new MIDI velocity curve on the latest OSes. But there's a new legacy velocity curve setting added to the menu. Just read the full change log.

ajstan wrote:From the v1.60 release notes:

"Morphs can be copied by pressing Monitor/Copy Panel + Wheel/ATouch/Ctrlped and pasted to another morph source (same procedure but with Shift button) Note: Morphs are copied/pasted on a per-panel basis.'

This will copy all of the assigned morphs. Make sure you delete the pedal morphs afterwards so they don't clash with the wheel morphs.

How do you delete the old control you copied from?

BuckW wrote:

ajstan wrote:From the v1.60 release notes:

"Morphs can be copied by pressing Monitor/Copy Panel + Wheel/ATouch/Ctrlped and pasted to another morph source (same procedure but with Shift button) Note: Morphs are copied/pasted on a per-panel basis.'

This will copy all of the assigned morphs. Make sure you delete the pedal morphs afterwards so they don't clash with the wheel morphs.

How do you delete the old control you copied from?

From Page 26 of the manual:

CLEARING A MORPH
Hold SHIFT and press a MORPH ASSIGN button to clear all Morphs for this source within the focused panel. To clear a particular assignment, hold the Morph Assign button and operate the control to remove the “gap” between the programmed setting and the Morph setting.