Missing Touch Response

[Saperu]

Hello

I need some help...

I`m using NS2 EX. I made split sound so that piano is upper and bass is lower. (Bass sound is made on the Synth side) However, the touch response only works on the piano side (upper), not bass side (lower). How do I get a touch response for bass sound?

I would be grateful if someone could help me!

[Spider]

A synth sound is not velocity sensitive by itself.
You must make it so by activating velocity sensitivity for Amp Env and/or Mod Env and/or Filter Cutoff.

[Saperu]

A synth sound is not velocity sensitive by itself.
You must make it so by activating velocity sensitivity for Amp Env and/or Mod Env and/or Filter Cutoff.

Thank you for the answer.

In the guide I can probably find out how to do that??

[anotherscott]

Yes, or in the synth section of the front panel, notice the buttons labeled "Velocity" (or "Vel").

[Mr_-G-]

I find in the NS2 the velocity of the amp to be way less than the piano dynamics and one way to improve on this is to also use the filter to control (Vel/ModEnv pot) to open the filter with the dynamics.

[be lee vit]

Here are some helpful posts to help you with the settings to add velocity sensitivity to samples:

http://www.norduserforum.com/nord-stage ... t8111.html

http://www.norduserforum.com/nord-stage ... 14600.html

[Saperu]

Touch response works again, Thank you all for your help!