I just purchaced this board and noticed that 4-5 keys was noticeable more sticky than other keys, actually if I released them very slowly, they stuck just before reaching top position.
Then after re-lubing, I assembled it again,and there was a little bit of change with the sticky keys, but not much.
So I looseded the screews for the keybed, didn't removed them entierly. And the preassure was gone. The keys was not sicky anymore.
When tightning lightly or with normal strength, it again strarts to get sticky.
When the keybed was on the table, all keys were perfect, all the same and no stickyness,
I suspect it gets bent somehow when all screws are back.
Any ideas on how to overcome this without having a loose keybed?
