Samples sound dull on Nord Wave 2!!
-
- Posts: 18
- Joined: 05 Jun 2011, 01:24
- 13
- Has thanked: 2 times
- Been thanked: 2 times
Samples sound dull on Nord Wave 2!!
All of the samples on my Nord Wave 2 sound dull. Do I always have to use the EQ section to brighten them up? Thank you.
- DJKeys
- Patch Creator
- Posts: 2055
- Joined: 11 Apr 2011, 17:11
- 13
- Your Nord Gear #1: Nord Stage 3
- Your Nord Gear #2: Nord Wave 2
- Location: Las Vegas
- Has thanked: 413 times
- Been thanked: 822 times
- Contact:
Re: Samples sound dull on Nord Wave 2!!
Make sure you turn on the filter. When a sample is loaded, it will turn the filter off my default. This also may depend on the signal chain of your monitoring system.
-dj
-dj
Last edited by DJKeys on 26 Nov 2023, 21:27, edited 1 time in total.
Nord Stage 3
Nord Wave 2
Yamaha U3
iMac i7 13.5.2
Studio One 5.5.2
Nektar T4
Drawmer DL 241
Focusrite ISA Two
Focusrite Clarett 8 Pre
-
- Posts: 60
- Joined: 09 Feb 2014, 00:26
- 10
- Your Nord Gear #1: Nord Piano 5
- Location: Eugene, Oregon
- Has thanked: 14 times
- Been thanked: 29 times
- Contact:
Re: Samples sound dull on Nord Wave 2!!
Make sure you select the RAW SMP (raw sample) option in the oscillator section when you use your sample. Otherwise, the sound may be filtered by a filter intended to make acoustic sounds more realistic, which is separate from the synth filter.
Nord Piano 5-73, Omnisphere, NI Komplete, Logic Pro.
Electro-jazz chill: https://echofabric.com
Electro-jazz chill: https://echofabric.com
-
- Posts: 9
- Joined: 21 Jul 2013, 17:09
- 10
- Your Nord Gear #1: Nord Wave
- Your Nord Gear #2: Nord Wave 2
- Location: Hagen
- Has thanked: 1 time
- Contact:
Re: Samples sound dull on Nord Wave 2!!
Same here.angelogogo0 wrote:All of the samples on my Nord Wave 2 sound dull. Do I always have to use the EQ section to brighten them up? Thank you.
Startet converting my samples from NW to NW2 this evening. Any time, i need a semitone-correction for the sample, it's getting dull when tuned down. Compared to the NW if you do this, the sample remains clean.
For example:
Sample played on C4 tuned semitones 0 = Good.
Sample played on C5 tuned semitones -12 = Bad. Same done on NW = everythings fine.
Sample played on C6 tuned semitones -24 = Very bad. Same done on NW = everythings fine.
I do not use any equalizer. The behaviour disagrees to my understanding of using samples. RAW SMP = no change.
-
- Posts: 15
- Joined: 15 Nov 2016, 22:58
- 7
- Your Nord Gear #1: Nord Stage 3
- Your Nord Gear #2: Nord Wave 2
- Been thanked: 4 times
Re: Samples sound dull on Nord Wave 2!!
I haven't found them to be dull, but they are not as loud as they are on my Fantom. I'm using mostly sound effects for a Pink Floyd band, stuff like the Money cash registers, etc. I even brought the original samples into Audacity and normalized the gain to get more volume, and they still play soft.
-
- Posts: 24
- Joined: 26 Jun 2017, 18:51
- 6
- Has thanked: 2 times
- Been thanked: 6 times
Re: Samples sound dull on Nord Wave 2!!
I'd like to hear a comparison between the two, if you still have both synths.sEIGu wrote:Startet converting my samples from NW to NW2 this evening. Any time, i need a semitone-correction for the sample, it's getting dull when tuned down. Compared to the NW if you do this, the sample remains clean.
For example:
Sample played on C4 tuned semitones 0 = Good.
Sample played on C5 tuned semitones -12 = Bad. Same done on NW = everythings fine.
I only had my NW1 and NW2 side by side for about a week to re-program my favorite patches. But that was long enough for me to decide the NW2 sounded pretty much the same, so I sold the NW1.
Nord uses some sort of compression algorithm for samples, so we have to assume the audio is band limited.