MIDI hub or another solution?

[Bjosko]

In the A, you have to defined which channel to let through.
Shift + Midi, then hold Shift and scroll to t and select the channel

[catosim]

In the A, you have to defined which channel to let through.
Shift + Midi, then hold Shift and scroll to t and select the channel

Yup, I've got that covered.The slot channels are different from my Soft-through channel.
If the soft channel wasn't right, I would not get any contact with the D-05 in my chain.
Thank you for the effort

[Bjosko]

Perhaps it only send aftertouch from the global channel, and you for example are sending through on a different channel?

[maxpiano]

C1884931-DDAC-47BF-A181-4C86AFAA94F1.jpeg

Seems like it are transmitting aftertouch

Interesting but I only see Note On/Off in the picture and a Reset, no AT (unless that Reset in your MIDI Monitor is the AT? Quite strange to see it represented in that way, since AT is a specific MIDI message)

[Bjosko]

Thats the brown colored values.
I will try again tonight with a synth as the 3. In chain.
(Hydrasynth, so not sure if it react on regular AT since itself are using poly aftertouch).

[Klangwerk]

Hi catosim,

I play with the same gear. I assume you are using the extern-section for that?
Maybe the soft-thru settings. Send on load in NS3?
The D-05 has Channel-Aftertouch. Here you will find the BIG MANUAL with al lot of MID-Implementations:

D-05_ParameterGuide_eng01_W.pdf

(1.6 MiB) Downloaded 130 times

Good luck,
Helmuth