unknown connector back panel Nord electro 6D

[Gus1+]

back panel.jpg (4.71 MiB) Viewed 2405 times

Good morning all.
i'm new to the forum, i just bought a nord electro 6 d, and i have a question regarding the rear panel.
To the left of the "monitor in" connector there is a location for a small rectangular 3-point plug which is not screen printed for use.
Anyone have any idea of its use?
(a test socket for after-sales service maintenance?)
thank you.
Regards Gus

[Hlaalu]

[attachment=0]
(a test socket for after-sales service maintenance?)

It's in the manual, but yes, something like what you say, or possibly used by Clavia for programming. Not something that has to do with the final user anyway.

[Gus1+]

Thanks, I don't see much else ...
Gus1+

[Gus1+]

[attachment=0]
(a test socket for after-sales service maintenance?)

It's in the manual, but yes, something like what you say, or possibly used by Clavia for programming. Not something that has to do with the final user anyway.

Exactly, from past threads (on the same/similar connector on other models) it is the one used by Nord factory for the keyboard calibration procedure.

[Gus1+]

Thank you for this precise answer

[CRClemens]

I have asked nearly the same question many years ago: The answer: general-nord-forum-f29/unknown-two-pin- ... html#p3360

[Gus1+]

Thank you