Nord User Forum

I have a micro modular that mostly works, editor software connects and I can load patches from the computer. But...

When I load my own custom patches onto the flash memory, the software says "memory protect is on". The manual has no information about disabling memory protect on this model. I've already re-flashed the firmware and the same error message appears.

Unrelated...the SHIFT key seems to be normally on, with the physical button never changing the state, despite it working on boot for a firmware upgrade.

I suspect these are electrical problems due to how old this model is. I took the board out of the enclosure and I can't see any jumpers to change memory protection. There are two trim pots with some really old nasty looking glue on them. Not really sure if this unit will work for a performance instrument since I can't load patches onto the internal flash.