Hi Folks,
All of a sudden I have a number of LED's that are staying lit no matter what program I am using. Please see the photo. It's the volume on the organ and piano and the six drawbars on the organ. From what I can it is not affecting the programs but I own a backline rental company and can not send it out like this on rentals.
Is anyone else having this issue?
Please help!!
3 posts
• Page 1 of 1
- davietough
- Posts: 2
- Joined: 26 Oct 2021, 01:35
- Country:
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord Stage 3
- Your Nord Gear #2: Nord Stage 2
Re: LED's are staying lit on my Stage 3
I believe Nords use a matrix-type control for the LEDs: If one of the control bits gets stuck, groups of LEDs all activate at the same time.
Possible causes could be debris on the circuit board shorting the control signal to ground (or Vcc), or the IC driving the control line might have failed.
There's a chance that a loose cable between the motherboard and the front panel control board might cause this behaviour too, so please check this also.
<edit> Also, Welcome to the forum!</edit>
Possible causes could be debris on the circuit board shorting the control signal to ground (or Vcc), or the IC driving the control line might have failed.
There's a chance that a loose cable between the motherboard and the front panel control board might cause this behaviour too, so please check this also.
<edit> Also, Welcome to the forum!</edit>
Last edited by pterm on 26 Oct 2021, 17:50, edited 1 time in total.
- pterm
- Donator
- Posts: 540
- Joined: 21 Aug 2012, 20:42
- Country:
- Has thanked: 198 times
- Been thanked: 206 times
- Your Nord Gear #1: Nord Electro 3
- davietough
- Posts: 2
- Joined: 26 Oct 2021, 01:35
- Country:
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord Stage 3
- Your Nord Gear #2: Nord Stage 2
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 36 guests