Stage 3 Edit "E" is always on the screen

[WannitBBBad]

In the synth window I have an "E" that seems to turn on when moving from one program to another that each use a synth preset, but not when the first program is using a synth created from scratch and not saved as a preset. I thought the "E" was showing whenever the programmed synth was different than the preset it was based upon, but that doesn't appear to be the case.

Had missed this post. I found the same thing a while ago. It must be a software bug.

nord-stage-forum-f3/list-of-nord-stage- ... ml#p136006

This was in fact the only time I got a reply from Clavia support for having reported a bug.

In any case, this is very different than the use case described, where flickering pots, buttons or drawbars cause the system to think some parameter has been adjusted.

I agree, Eriknie addressed the original issue, but probably good to hit on both points so folks aren't searching for a bad pot, slider, or button when this occurs and is repeatable.

[torgojones]

This happened to me as well. I factory defaulted my Nord thinking it was messed up, but after the reset it still had the edit symbol even though everything sounded fine. I turned every knob on my Stage 3 and then changed to another program and the "E" went away for good. I guess one of the knobs was in some sort of in-between state or something. I'm glad that was all it was. Hope this helps.

[elsongs]

Do you have your sustain pedal assigned turn on your rotary speaker for organ patches? If so, even when you're using a non-organ patch, every time you hit the sustain pedal, it turns on and off the "E" edit icon.