Nord User Forum

[anotherscott]

Also, I had some luck programming some extra "tonk" sounding percussion on the second panel , layered and split and faded for the lower left hand notes. Even got the wheel boosting the volume of the tonk.

Nice idea. It gives me another idea... I've wished for a higher key click level (like you can get on the E5). Maybe I could create key click samples that I could load into the synth section and layer with organ sounds.

[analogika]

Even the drawbars need enhanced on the NS3C!

How so…?

[stopmakingsense]

Regarding adding Click volume.

It's worth adjusting the following...

Boosting Mid Range EQ
Boosting compression

That's of course after adjusting click level in the sub menu.

[hernjov1]

@ Analogika It seem to me that when pulling out the drawbars. The harmonic tones are softer than my B-3 organ...

[analogika]

@ Analogika It seem to me that when pulling out the drawbars. The harmonic tones are softer than my B-3 organ...

What do you mean by "softer"?

Do you mean that the relative volumes of the drawbars are different from your B3?

[aureliopenna]

Hello Guys, this is probably already mentioned before, but if you turn on leslie than stops the organ sound through channels 3/4?
By the way does they tweak the hammond on 2.20? It's sound more warm in a good way too me.

[Schorsch]

Hi Aurelio,

yes correct, switching on Leslie on the NS3 routes the organ sound to output 1+2 only, there is no way to have the organ sound including the internal leslie go to output 3+4. I am making use of this since I am usually routing the organ to output 3 (mono) and then into my Neo Ventilator II, from there in stereo into a Hall of Fame (internal reverb does not go to output 3 either) and finally into the PA. I have set the rotor speeds/balance of the internal Leslie to different values than the ones of the Neo Ventilator, so if I want to use the speed settings of the internal Leslie (and also different reverb settings from the internal reverb simulation) I just have to switch this on and it is routed through outputs 1+2, so no longer goes to the Neo Ventilator II. A bit more flexibility from my point of view.

[aureliopenna]

THank you Schorsch,

Seems like a nice setup indeed!

[Schorsch]

It is - I also route the organ section of my NS2EX-88 via output 3 through the same Neo Ventilator like the NS3 organ when use over on stage, mix both with a Radial Mix 2:1 into the Ventilator input and control the speed with the Nord half moon switch. Improves the organ sound of the NS2 a lot

[Jo Osantos1]

Hello Guys, this is probably already mentioned before, but if you turn on leslie than stops the organ sound through channels 3/4?
By the way does they tweak the hammond on 2.20? It's sound more warm in a good way too me.

I will give it a try as well!