Nord User Forum

[DTownSMR]

I don't see any CC's listed so I'm guessing there's no MIDI support for controlling the organ engines rotary speaker controls but I'm hoping I'm just over looking something. Thanks in advance.

[FZiegler]

Did you have a look into the manual? There are the following MIDI CCs:

Rotary Speed	108
Rotary Source	109
Rotary Drive	110
Rotary Enable	111

[DTownSMR]

Thanks, yes I've tried them they don't seem to have any effect.

[DTownSMR]

I did just retry them all and found that Speed, Source & Enable have no effect the Drive does seem to function. Odd?!?

[FZiegler]

If you have a MIDI monitor app on your computer, you may check which CCs are sent when using the control panel. What is sent should also work if received. I don't have my hands on the Stage 3.

[DTownSMR]

I'll see if I can dig one up. Thanks.

[DTownSMR]

Looks like it's all off of CC:108 ?!?
values: 0 - stop
43 - on slow
85 - on fast
127 - fast

I was using dial switches which were readily available and I guess the flood of messages confused it. Need to play around some more. Thanks for the tips.

[Klondyke77]

Looks like it's all off of CC:108 ?!?
values: 0 - stop
43 - on slow
85 - on fast
127 - fast

I was using dial switches which were readily available and I guess the flood of messages confused it. Need to play around some more. Thanks for the tips.

I can confirm CC:108 and states 43-slow, 127-fast.
These values I use in my DIY arduino MIDI-box with my NS3 - and they work! But intention there is only to toggle between slow and fast with a momentary switch / pedal switch. (same as if you plug the pedal in ROTOR PEDAL Jack)