Cleaning the contacts....
is there a way , or a tool, ...to get the rubbers back to their little holes, ...half an hour to have just a few done...!
3 posts
• Page 1 of 1
Re: Cleaning contacts...
I think I remember this tool working okay. It’s a plastic o-ring pick. It might have for the bigger nubs…I seem to remember using this pick to push it through from the back side and trying to grip the “male” part with tweezers. That way you can kind of work the nub through the hole from both ends. I can’t quite remember if the pick was small enough for the smaller nubs. I might have had to use a paper clip which was annoying because the metal edges were more likely to poke through the silicon rubber.
https://simplybearings.co.uk/shop/product_info.php?products_id=153030¤cy=USD&gclid=CjwKCAjw9NeXBhAMEiwAbaY4lkMDvGTcqzOEzli1ky0MXDw4dEDTtyl7UvX88HB5LOpYy1vfojNB6RoCYCgQAvD_BwE
Hope that helps! It was a painstaking process for me too.
https://simplybearings.co.uk/shop/product_info.php?products_id=153030¤cy=USD&gclid=CjwKCAjw9NeXBhAMEiwAbaY4lkMDvGTcqzOEzli1ky0MXDw4dEDTtyl7UvX88HB5LOpYy1vfojNB6RoCYCgQAvD_BwE
Hope that helps! It was a painstaking process for me too.
65 Wurlitzer 720B, 59-ish Hammond M3 & 50's Leslie 44W
-
be lee vit - Posts: 77
- Joined: 03 Jul 2016, 04:12
- Country:
- Has thanked: 81 times
- Been thanked: 28 times
- Your Nord Gear #1: Nord Stage 2
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 45 guests