Triple Pedal Problems
-
FZiegler
- Donator
- Posts: 2385
- Joined: 15 Dec 2019, 02:41
- Your Nord Gear #1: Nord Stage 3
- Location: Germany south-west
- Has thanked: 633 times
- Been thanked: 794 times
- Contact:
Re: Triple Pedal Problems
Of course, the picture shows a TS plug whereas the Triple Pedal needs a TRS type. Even if that's not your point.
Stage 3 Compact (Rev.B 2.1 - OS 2.60) - Kawai VPC1 / Yamaha CP33 - Hall of Fame & NeoVent2 - Behringer Flow-8 - K&M stands 18820+18811 / 18953+18952 - Samsung tablet with MobileSheetsPro & AirTurn Duo200 - QSC K8.2s / Fischer InEars
Re: Triple Pedal Problems
I know Ziegler, 
it's just an explanatory image to explain that the solder that came loose is the one that goes inside that connector, and not the solder on the pedal.
it's just an explanatory image to explain that the solder that came loose is the one that goes inside that connector, and not the solder on the pedal.
Last edited by Recamales on 26 Sep 2023, 16:35, edited 1 time in total.
-
Carl393
- Posts: 7
- Joined: 13 Sep 2023, 03:37
- Your Nord Gear #1: Nord Piano
Re: Triple Pedal Problems
Yes the connectivity works, just tested. I think it's the carbon contacts on the board.
I tried swapping the rubber contacts with the one that I know works and that didn't help either
Did the whole isopropyl alcohol thing that didn't work either.
I tried swapping the rubber contacts with the one that I know works and that didn't help either
Did the whole isopropyl alcohol thing that didn't work either.
-
groovejazz
- Posts: 8
- Joined: 05 Apr 2014, 14:55
- Your Nord Gear #1: Nord Grand
- Your Nord Gear #2: Nord Stage 3
- Location: Karlsruhe
- Has thanked: 1 time
- Contact:
Re: Triple Pedal Problems
Usually the cables are of real bad quality, not only by Nord, also by Yamaha etc. I repared a lot of pedals by changing the cable. So I did with my two Nord Triple Pedals as they stopped working after short time and now they seem to last. This is no big deal for everyone who is a little experienced in soldering