Can anyone else confirm this happens?
My system:
Electro 6D 61
OS 2.5
Mac Mini Mojave 10.14.6
USB cable connected directly to Mac - nu USB hub
No external USB hubs plugged into Mac
USB lead with a Ferrite Core (then tested with normal USB lead)
Test:
Switch on Electro and load Sample Editor 3
Wait for Electro to synchronise
Pick any program and save it to the same location - save should be instant
Quit the Editor
Check:
Now save the program again - Electro hangs for up to 7 seconds in STORE PROGRAM TO then finally returns to program screen. Same problem even if I create a new sample patch.
I have to reboot the Electro to clear this problem. I don't have a PC but will try it in Parallels.
2 posts
• Page 1 of 1
Re: Sample Editor 3 Bug after closing
UPDATE
I have now tested it in WIndows 7 running on Parallels on my Mac. No issues - so I'm sure it's just a Mac problem.
The key difference between the Operating System: Mac is using Class Compliant so no drivers required whereas on Windows you have to install the Clavia USB driver. That could be where the problem lies.
Same problem in Catalina 10.15 - I will contact Tech Support.
Watch this space.
I have now tested it in WIndows 7 running on Parallels on my Mac. No issues - so I'm sure it's just a Mac problem.
The key difference between the Operating System: Mac is using Class Compliant so no drivers required whereas on Windows you have to install the Clavia USB driver. That could be where the problem lies.
Same problem in Catalina 10.15 - I will contact Tech Support.
Watch this space.
Last edited by vcfvca on 11 Sep 2020, 11:24, edited 2 times in total.
- vcfvca
- Posts: 148
- Joined: 22 Dec 2012, 18:57
- Country:
- Has thanked: 18 times
- Been thanked: 63 times
- Your Nord Gear #1: Nord Electro 6
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 64 guests