Hi,
I just got a brand new Electro 6D 73. What a fantastic keyboard. Today I bought an Yamaha FC7 foot control to use as a volume pedal in the organ and synt mode.
I went into the setup menu and changed to the Yamaha FC7. Two problems: The pedal works "in reverse". Meaning that when it's in the Zero position it's 100% and when i
put it in max it's ca 50%. The other thing is that it's very un-linear. Mening that as soon as I move the pedal it goes from 50% to 100%. I've read the manual for both the
Electro 6 and the FC7 and I can't see thet there is anywhere I can change this. Thanks for any input from a Newbie.
3 posts
• Page 1 of 1
- Flintstones
- Posts: 3
- Joined: 27 May 2022, 14:42
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord Electro 6
Re: Pedal to Nord electro 6D 73
Hi, check that you have inserted the jack in NE6 Ctrl Pedal port fully, if OK then you may have a defective pedal (test it with a multimeter)
Last edited by maxpiano on 27 May 2022, 20:06, edited 1 time in total.
-
maxpiano - Patch Creator
- Posts: 6243
- Joined: 27 Jun 2011, 13:29
- Location: Italy
- Country:
- Has thanked: 447 times
- Been thanked: 2194 times
- Your Nord Gear #1: Nord Stage 3
Re: Pedal to Nord electro 6D 73
Hi. I inserted the plug properly now and it works perfekt. Thank you ever so much.
- Flintstones
- Posts: 3
- Joined: 27 May 2022, 14:42
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord Electro 6
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 29 guests