Dear All
I'm facing the following problem with my brand new C2D, OS 1.10:
The left half of the lower manual (up to note g in the 3rd octave) is controlled by the upper manual drawbars, the left half of the upper manual is controlled by the lower manual drawbars. On the right everything is fine. The problem occurs in all organ model and in all presets.
In other words: The left half of the manuals seem to be wrongly assigned / seem to be interchanged.
Is there anything that I can do or do I have a hardware problem?
Thanks a lot
Rainer
3 posts
• Page 1 of 1
- RainerKlang
- Posts: 2
- Joined: 12 Nov 2014, 01:00
- Country:
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord C2D
Re: Wrongly assigned octaves: Hardware or software problem?
Didn't this crop up a while back - a result of mis-connected ribbon cables inside? Have a search back in the older posts and you might find the thread.
- tacitus
- Posts: 124
- Joined: 19 Sep 2013, 10:14
- Country:
- Has thanked: 3 times
- Been thanked: 32 times
- Your Nord Gear #1: Nord C2D
Re: Wrongly assigned octaves: Hardware or software problem?
You are right. I found a thread from floydology. Not the best quality control at Clavia.
Thnaks a lot
Rainer
Thnaks a lot
Rainer
- RainerKlang
- Posts: 2
- Joined: 12 Nov 2014, 01:00
- Country:
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord C2D
3 posts
• Page 1 of 1
Return to Nord C1 / C2 / C2D Organ Forum
Who is online
Users browsing this forum: No registered users and 19 guests