Sorry, but I was trying to reply to an older thread and wasn't able to post to it.
I am trying to find out is I need to modify set list entries for those times when I send a mono signal to the FOH vs when I use a Motion Sound stereo amplifier.
"So... I don't have to go through and change all of my setlist entries to "mono" for those times when I am not using stereo for FOH? Either L or R output sends a full signal in mono when only one output is used? To me, the L and R outputs sent to a mono amp sound the same.
I have two typical setups. A Motion Sound stereo amp playing in stereo for smaller gigs (not sending to the PA) and when I send to the PA I send a single output from the MS to the board. I just want to make sure the FOH is hearing everything I am."