Hi,
I'm using the Nord G2 Editor to emulate my Yamaha CS-15D...
Problem is: LFO ---> VCO.
In hardware: Modulation at 100%, LFO Square wave has +6 notes & -9 notes, like police sirens.
In Software: I can make a +6 & -6 or +9&-9.
But can't give different values to positive & negative.
LevelAdd affects both +&-,
Splitting LFO signal with 2x LevelConvert does not work.
Just need some diodes to split the signal, and a Bias of -3 to the -6 signal.
Any Ideas.?
3 posts
• Page 1 of 1
- JuanPC
- Posts: 1
- Joined: 29 May 2015, 05:52
- Country:
- Has thanked: 0 time
- Been thanked: 0 time
- Your Nord Gear #1: Nord Modular
Re: Nord G2 Editor Help!
It's been a long time since I patched, but I think I would have used that level converter to separate the positive and negative parts of the LFO, multiplying one of them and add them again.
I'll have a look. Please ring me if I don't come back
I'll have a look. Please ring me if I don't come back
-
stiiiiiiive - Posts: 664
- Joined: 14 Oct 2011, 15:07
- Has thanked: 67 times
- Been thanked: 132 times
- Your Nord Gear #1: Nord Modular
- Your Nord Gear #2: Nord Electro 4
Re: Nord G2 Editor Help!
So.
It was not the Converter but the Rectifier
Here is some material :
It was not the Converter but the Rectifier
Here is some material :
- The author stiiiiiiive was thanked by:
- pablomastodon
-
stiiiiiiive - Posts: 664
- Joined: 14 Oct 2011, 15:07
- Has thanked: 67 times
- Been thanked: 132 times
- Your Nord Gear #1: Nord Modular
- Your Nord Gear #2: Nord Electro 4
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests