Hi
Im a new happy owner of a NordLead 4 I love the sound and the build quality except the cutting of front metal panel near the keayboard (lowest C).
Just take a look (pic attached) - metal is not cut in line [when you slide youre finger You feel a cut/bladelike edge? I know that Nords are handmade but this cutting is like from a student holding first time his tool. I'm a little disappointed of the Quality Check specially I own many metal gear and never seen cuttings like this. The rest of this Keybord looks great but this side
Here my question.. Is it common or it's just my bad luck. How is You're Nord?
3 posts
• Page 1 of 1
Re: Nord Lead 4 front metal panel cutting quality
Hej!
I just checked my four Nords ... only the edges of my NL4 is a bit rough, in the area you are pointing out.
I apologize on behalf of my fellow Swedish engineers in Stockholm.
/Vänligen
Michael in Scania
I just checked my four Nords ... only the edges of my NL4 is a bit rough, in the area you are pointing out.
I apologize on behalf of my fellow Swedish engineers in Stockholm.
/Vänligen
Michael in Scania
NE3HP, NP88, NS2, DPP1, NL2X, NL2X, NLA1, NL4, NE5D, NW2 (Collect Them All?), some classic Rolands, Arturias, a Waldorf, a Kurz, a WONOK3, a pile of guitars, a P-bass, loopers, amps and computers ...
I'm a gearslut!
I'm a gearslut!
-
Marlowes - Patch Creator
- Posts: 1342
- Joined: 14 Sep 2011, 12:10
- Location: Österlen, Scania
- Country:
- Has thanked: 1820 times
- Been thanked: 594 times
- Your Nord Gear #1: Nord Wave 2
- Your Nord Gear #2: Nord Lead 4
3 posts
• Page 1 of 1
Return to Nord Lead / Rack Forum
Who is online
Users browsing this forum: No registered users and 27 guests