Have a strange problem that I can't solve. I have an Electro 5D, and play both electric guitar and the Nord in my band. During shows, I'll sometimes be required to play guitar while standing in front of or near the Nord. When I do, the Nord is creatong some major interference with my Telecaster's single coil pickups, resulting in the most God-awful hum and noise through the PA or amp, whichever I'm using. I have fully shielded my Tele, which entailed appliing conductive paint and foil to the cavity. It is virtually noiseless when I'm not in close proximity to the Nord. The only solution I can see is to turn the Nord off when I am not using it during a gig on songs where I'm playing guitar.
Is there anyone out there experiencing the same issue? I am looking for any suggestions to shield the frequencies/interference that are coming from the Nord. It's almost bad enough to make me consider selling it, which would suck mightily.
Thanks!
Dave
30 posts
• Page 1 of 3 • 1, 2, 3
Re: Noise - what's a guitarist / keyboardist to do?
Well, I did some digging here on the forum for similar experiences in Nord-land (gotta remember to do that first in the future), and found several that are is identical. Appears to be without a solution.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Davek
- Posts: 23
- Joined: 16 Jun 2016, 17:07
- Country:
- Has thanked: 4 times
- Been thanked: 1 time
- Your Nord Gear #1: Nord Stage 2 EX
Re: Noise - what's a guitarist / keyboardist to do?
Hi,
I can't believe that this is normal. Have you checked out if you have the same behavior with another Nord keyboard? I'm pretty sure that this is a problem of your individual instrument.
Greets,
Eumel
I can't believe that this is normal. Have you checked out if you have the same behavior with another Nord keyboard? I'm pretty sure that this is a problem of your individual instrument.
Greets,
Eumel
Nord Stage 4 88
Nord Electro 6 compact
Nord Electro 6 compact
-
Eumel - Patch Creator
- Posts: 325
- Joined: 31 Jul 2014, 16:16
- Location: Straubing
- Country:
- Has thanked: 286 times
- Been thanked: 161 times
- Your Nord Gear #1: Nord Stage 4
- Your Nord Gear #2: Nord Electro 6
Re: Noise - what's a guitarist / keyboardist to do?
Eumel wrote:I can't believe that this is normal. Have you checked out if you have the same behavior with another Nord keyboard? I'm pretty sure that this is a problem of your individual instrument.
It may not be normal, but this has been reported by a number of users.
I believe that the mains transformer in some Nord power supplies leak magnetic fields outside the transformer and into the space near the keyboard. Users recorded audio samples of the noise, and its definitely at mains frequency (and harmonics thereof).
Video was posted demonstrating how the guitar's proximity to the Nord increased the noise level.
It's certainly real, and one of Nord's weaknesses.
- pterm
- Donator
- Posts: 540
- Joined: 21 Aug 2012, 20:42
- Country:
- Has thanked: 198 times
- Been thanked: 206 times
- Your Nord Gear #1: Nord Electro 3
Re: Noise - what's a guitarist / keyboardist to do?
I have the same problem, described it last year in a post; It's a weakness of the nord power supply, and there's still no solution. I'll try to keep the best distance with my guitar to the power supply of the NE5 to minimize the electrical interferences.
Here my post and the reactions to it:
nord-electro-forum-f9/electrical-interferences-of-nord-electro-produce-disturbing-t10977.html
Here my post and the reactions to it:
nord-electro-forum-f9/electrical-interferences-of-nord-electro-produce-disturbing-t10977.html
- rudiratlos
- Patch Creator
- Posts: 72
- Joined: 18 Jun 2015, 21:38
- Country:
- Has thanked: 31 times
- Been thanked: 74 times
- Your Nord Gear #1: Nord Electro 5
- Your Nord Gear #2: Nord Stage 3
Re: Noise - what's a guitarist / keyboardist to do?
Here is a wild stab in the dark folks.
Back in the 60s, my dad experienced the same issue with the gear of the day - recording and sound equipment. These were the early days of component stereo. I forget the exact scenario because I was only about 10 years old, however, I remember him mentioning he used a sheet of 1/4 inch aluminum between the two devices to scramble the magnetic field. I'm unsure how this could be applied between the Nord and a Tele. I'll probably be told that it is not the right answer, but it worked for him. Now that I think of it, I think dad had the hum issue when he had a turntable on one shelf and a tape recorder on the shelf beside it. He placed a vertical piece of aluminum between the two devices, glued to one of the vertical shelf walls separating the two devices. The hum was gone. Not sure how this could be implemented with a Nord and Tele. Perhaps you could have someone hold a piece between the two devices to see the affect. I believe aluminum foil may work too. At this point, I suspect you're willing to try anything .
Are there any electrical engineers out there in Nordland?
Back in the 60s, my dad experienced the same issue with the gear of the day - recording and sound equipment. These were the early days of component stereo. I forget the exact scenario because I was only about 10 years old, however, I remember him mentioning he used a sheet of 1/4 inch aluminum between the two devices to scramble the magnetic field. I'm unsure how this could be applied between the Nord and a Tele. I'll probably be told that it is not the right answer, but it worked for him. Now that I think of it, I think dad had the hum issue when he had a turntable on one shelf and a tape recorder on the shelf beside it. He placed a vertical piece of aluminum between the two devices, glued to one of the vertical shelf walls separating the two devices. The hum was gone. Not sure how this could be implemented with a Nord and Tele. Perhaps you could have someone hold a piece between the two devices to see the affect. I believe aluminum foil may work too. At this point, I suspect you're willing to try anything .
Are there any electrical engineers out there in Nordland?
Last edited by Lee Batchelor on 30 Jan 2017, 15:03, edited 3 times in total.
- Lee Batchelor
- Posts: 246
- Joined: 09 Oct 2016, 16:54
- Country:
- Has thanked: 61 times
- Been thanked: 28 times
-
Mr_-G- - Moderator
- Posts: 4616
- Joined: 18 Aug 2012, 16:48
- Has thanked: 1475 times
- Been thanked: 1257 times
- Your Nord Gear #1: Nord Stage 2
Re: Noise - what's a guitarist / keyboardist to do?
Weird timing on this. The bass player (who also does some keyboard work) in the band before us at a show this past weekend, when he saw I was using a nord told me that he used to have a Nord too. Unfortunately he had to send it back because of the terrible noise that would happen if he stood to close to it with his bass on.
- skydogg
- Posts: 17
- Joined: 06 Jan 2017, 19:06
- Country:
- Has thanked: 2 times
- Been thanked: 2 times
- Your Nord Gear #1: Nord Electro 5
Re: Noise - what's a guitarist / keyboardist to do?
Lee Batchelor wrote:Back in the 60s, my dad experienced the same issue with the gear of the day - recording and sound equipment. These were the early days of component stereo. I forget the exact scenario because I was only about 10 years old, however, I remember him mentioning he used a sheet of 1/4 inch aluminum between the two devices to scramble the magnetic field. I'm unsure how this could be applied between the Nord and a Tele. I'll probably be told that it is not the right answer, but it worked for him. Now that I think of it, I think dad had the hum issue when he had a turntable on one shelf and a tape recorder on the shelf beside it. He placed a vertical piece of aluminum between the two devices, glued to one of the vertical shelf walls separating the two devices. The hum was gone. Not sure how this could be implemented with a Nord and Tele. Perhaps you could have someone hold a piece between the two devices to see the affect. I believe aluminum foil may work too. At this point, I suspect you're willing to try anything .
Similar idea discussed in https://www.norduserforum.com/post45096.html?hilit=mu%20metal#p45096
- pterm
- Donator
- Posts: 540
- Joined: 21 Aug 2012, 20:42
- Country:
- Has thanked: 198 times
- Been thanked: 206 times
- Your Nord Gear #1: Nord Electro 3
Re: Noise - what's a guitarist / keyboardist to do?
I play a Nord 5 and guitar in a band and I have no issues with noise. I always make sure that my guitar amp and pedals are in the same outlet as the Nord.
- qreative
- Posts: 9
- Joined: 30 Aug 2015, 14:34
- Country:
- Has thanked: 0 time
- Been thanked: 6 times
- Your Nord Gear #1: Nord Electro 5
30 posts
• Page 1 of 3 • 1, 2, 3
Who is online
Users browsing this forum: No registered users and 22 guests