Nord User Forum

[flmc59]

Here are my settings

ToneWheel model = Vintage 3 (most hammonds are pretty leaky)
Klick bounce = on
Klick level = high (A B3 klicks more than you think)
Bass + mid = 0 db
Treble = - 5 db (the 122 leslie rolls of at 6000)
dist = on
Dist level = 5
Leslie simulation = 122
Bass/Horn = 70 bass / 30 Horn
Percussion volume soft/normal = Medium
I normally use the default Leslie acell speed
Delay on (swell led off) adding dealy with the settings below add ambience to the sound
Delay tempo = 10
Delay Amount = 5
Feedback = 1
Reverb Stage 1
Reverb volume = 4 (to much of sound a little wierd in with leslie on fast)

Eq settings also depend on the room you play in.

[brakmoll]

Took some time to get used to the new Nord sound but here are my settings, sounds fantastic!

ToneWheel model = Vintage 3
Klick bounce = on
Klick level = high
Bass = 0- -5db
Treble = - 5 db
dist = on
Dist level = 5-7
Leslie simulation = 122 close
Bass/Horn = normal
default Leslie acell speed
Reverb Stage 1 0-5

/Henrik

RIP Mr Lord

[Mooser]

Are these "set-ups" for going directly into a board, or into an instrument amp or PA. Stereo or mono? Do you use different choices for the different conditions?

[flmc59]

I do kot vary these settings a lot.
In a leslie i will pull up the treble a bit since they normally roll of at 6000 hz

[dlargent]

Here are the settings for my C2 (updated to 'C2D' sound)


ToneWheel model = Vintage 3
Click bounce = on
Click level = normal
Bass = 0 or +3db for quiet gigs
dist = on
Dist level = 4 (just enough that you hear it when you hit the gas)
Leslie simulation = 122
Bass/Horn = 50/50
Percussion volume soft = either medium or high depending on my mood
Leslie fast speed = low
Reverb Stage Soft (Trying to recreate the sound of PR-20 reverb...)
Reverb volume = 4