I just bought a used Nord C1 and I'd like to reload the original sounds settings.
I read and reread the doc of the C1 midi-part, but I don't understand how to use the syses file.
With my mac, I run "SysEx Librarian" program, I load the file NordC1Factory-3.syx (downloaded on the Nord website), I do "play" and nothing happens ...
Should the C1 be connected to USB or MIDI jack ? Which parameters to choose in C1 ?
If anyone could help me!
Thank you.
3 posts
• Page 1 of 1
- roberstein
- Posts: 8
- Joined: 20 Jan 2014, 16:56
- Country:
- Has thanked: 1 time
- Been thanked: 1 time
- Your Nord Gear #1: Nord Electro 3
- Your Nord Gear #2: Nord Stage 2
Re: C1 how to original sounds settings reload
Check page 19 of the C1 Manual (available on Nord site) about restoring Sysex dumps (key point: ensure Memory Protection is switched off).
C1 does not support MIDI over USB so you need to use a MIDI interface, make sure also you are using a good quality one as some cheap MIDI USB cable interfaces fail to transfer sysex streams properly.
C1 does not support MIDI over USB so you need to use a MIDI interface, make sure also you are using a good quality one as some cheap MIDI USB cable interfaces fail to transfer sysex streams properly.
Last edited by maxpiano on 31 Jan 2017, 15:15, edited 5 times in total.
- The author maxpiano was thanked by:
- pablomastodon
-
maxpiano - Patch Creator
- Posts: 6243
- Joined: 27 Jun 2011, 13:29
- Location: Italy
- Country:
- Has thanked: 447 times
- Been thanked: 2194 times
- Your Nord Gear #1: Nord Stage 3
- roberstein
- Posts: 8
- Joined: 20 Jan 2014, 16:56
- Country:
- Has thanked: 1 time
- Been thanked: 1 time
- Your Nord Gear #1: Nord Electro 3
- Your Nord Gear #2: Nord Stage 2
3 posts
• Page 1 of 1
Return to Nord C1 / C2 / C2D Organ Forum
Who is online
Users browsing this forum: No registered users and 20 guests